01-09-2015, 11:36 PM
He has to put anything he imagines on the paper and when the clients approve, he starts working.
Machines help a lot. He uses machines to get to the level where he can start using hand tools. Otherwise it would take him a lot of time. Especially in the case where he has to drill the hole through the stone 10-15cm wide. I've tried doing what my brother does - I took the hammer and a chiselt. It was tricky to guess the amount of strength to use. I was afraid not to make a mistake and damage my brother's work. When he does it it looks so easy. :)
CNC's are for mass production. This is all about the skills.
Machines help a lot. He uses machines to get to the level where he can start using hand tools. Otherwise it would take him a lot of time. Especially in the case where he has to drill the hole through the stone 10-15cm wide. I've tried doing what my brother does - I took the hammer and a chiselt. It was tricky to guess the amount of strength to use. I was afraid not to make a mistake and damage my brother's work. When he does it it looks so easy. :)
CNC's are for mass production. This is all about the skills.

![[Image: 6xRDo1o.png]](http://i.imgur.com/6xRDo1o.png)
![[Image: EU3EZoq.png]](http://i.imgur.com/EU3EZoq.png)
![[Image: eNAvNT0.png]](http://i.imgur.com/eNAvNT0.png)
![[Image: E23L6j9.png]](http://i.imgur.com/E23L6j9.png)
![[Image: kQuqmS0.png]](http://i.imgur.com/kQuqmS0.png)
![[Image: EtYqOrS.png%5D]](http://imgur.com/EtYqOrS.png%5D)